Bathroom floors look amazing after installing a glass mosaic on the floor. Many people are intimidated by mosaics, especially with how to install the hexagon tile floor. But we are here for help with our mosaic tiling tips and tricks. Let’s find out more.

How to install mosaic

The layout

Two kinds of mosaic tiles are available: those with mesh on the back as well as those with paper on its front. If your mosaics are covered in a solid sheet of material, the material facing you must be mounted. With the mesh down, mount mosaics covered in mesh. Take the time to directly map out the mosaics on the floor where you can mount them. To help you bring the pattern together, patterned mosaics can be numbered with arrows. To get the pattern right, some can require trial and error. To ensure that you have the pattern right as well as the distance between the sheets, spread out the sheets in complete rows, and step back sometimes.

The cutting

To suit the perimeter of the room, you will need to trim most mosaic tiles and tile sheets. With a pair of scissors between the tiles, you can trim the sheets, whether paper-faced or mesh-mounted. With tile nippers built for the type of tile being mounted or with a tile wet saw, you can cut the tiles on the sheets by sliding the whole sheet through the saw.

The installation

After setting out the mosaics, in the opposite order in which you set them down, pick them up from the floor. Using a trowel to spread thin mortar onto the floor and comb it until the mortar has a uniform depth. Then, turn the trowel around and smooth the ridges out. This will keep between the mosaics from seeping up the excess mortar. In the same pattern as you spread them out, press the sheets into the mortar. To push the sheets evenly into the mortar, lay a beating block over the tiles and tap it gently with a mallet.

Removal of Paper-Face

Offer the paper-faced material one hour for the mortar to start healing after you have mounted the mosaics, then remove the paper. The paper is held by a water-soluble glue to the face of the mosaics. The adhesive is removed using a sponge soaked in water and added to the paper. Peel away the paper from the mosaics. Push it back into place with your fingertips if a tile comes loose. Using the trowel's edge to straighten out any uneven mosaic lines.

Grouting operations

24 to 48 hours after you have mounted the mosaics, grout everything. Cast the grout with a grout float kept at a 45-degree angle to the floor over the entire floor. The grout will set up enough for you after about 10 minutes to clean the excess from the surface of the mosaics. Work a slightly dampened grout sponge over the mosaics' surface in loops, rinsing it regularly until the mosaics are clean.

There you have it, your mosaic!